How to Reach the Fuel/Ign Menu

In order to perform the diagnostic tests, you must operate the DRBII to reach the ABS MENU level within the ABS diagnostic program. At the ABS MENU, you can:

- read fault messages
- select DRBII test functions

The instructions below tell you how to reach the ABS MENU.

If you already know how to reach the ABS MENU, see "How to Select a DRBII Test Function" found later in this HELP 1 for instructions on how to select a DRBII test function.

A. Connect the DRBII to the vehicle by plugging the DRBII connector into the engine diagnostic connector.
B. Turn the vehicle's ignition switch to the "RUN" position.

NOTE: Do not touch the keypad during the DRBII power-up sequence or an error will result.

C. The copyright date and diagnostics program version number will be displayed briefly similar to the following:

1991 DIAGNOSTICS COPYRIGHT (c) 1990
CHRYSLER CORP. V2.FO
PRESS F3 FOR HELP

NOTE: The version number (V2.FO) is subject to change. It may not appear on the display exactly as it is illustrated above.

D. After a few seconds, the display will change to read as follows (or press ENTER to change the display immediately):

DRBII
1) VEHICLES TESTED
2) HOW TO USE

Press the down arrow twice to view the rest of the menu. The screen will display:

DRBII
2) HOW TO USE
3) CONFIGURE
4) SELECT SYSTEM

NOTE: For an explanation of items 1), 2), and 3), see "How to Use the DRBII Menu" found later in this HELP 1.

E. Select 4) SELECT SYSTEM to enter the diagnostic test program. The display will change to read as follows:

SELECT SYSTEM
1) ENGINE
2) TRANSMISSION

F. Press the down arrow three times to view more of the menu.

SELECT MODULE
3) BODY
4) SUSPENSION
5) ABS

G. Select 5) ABS to enter the ABS system part of the DRBII program. The display will change to read as follows:

ABS SYSTEM-10

VERSION XXXXXXXX

NOTE: The version number is subject to change. It may not appear on the display exactly as it is illustrated above.

H. After a few seconds, the screen will display a menu of the DRBII test categories for the antilock brake system as follows (or press ENTER to change the display immediately):

ABS MENU

1) SYSTEM TEST
2) READ FAULTS

Press the down arrow three times to view the rest of the menu. The screen will display:

ABS MENU
3) STATE DISPLAY
4) ACTUATOR TESTS
5) ADJUSTMENTS

At this point, you have reached the ABS MENU of the ABS diagnostic program. Now you can select any of the specific test functions that have been programmed into the DRBII cartridge.