MST-6100 ABS System Tester Hookup Procedure

MST-6100 ABS System Tester Hookup Procedure

Install the tester by following these steps:
1. Turn vehicle ignition off.
2. Open vehicle trunk and pull back rear seat bulkhead trim panel to gain access to Anti-lock Brake Control Module (ABM) connector.
3. Disconnect ABCM connector by pulling lock plate away from connector and pivoting harness connector away from ABCM.
4. Connect large end of tester harness to vehicle harness.
5. Connect small end of tester harness to either the PINOUT Box connector or the Vehicle System Tester connector as required.