Rear Wheel Speed Sensor (Figs. 11 and 12)

Fig. 11 - Rear Wheel Speed Sensor Routing at Trailing Arm:

Fig. 12 - Body Routing of Rear Speed Sensor Wiring:

REMOVAL

(1) Raise vehicle and remove wheel and tire assembly.

(2) Remove sensor assembly grommet from underbody and pull harness through hole in underbody.
(3) Unplug connector from harness.

(4) Remove sensor grommet bracket screw f rom body hose bracket, just forward of trailing arm bushing.

(5) Remove sensor assembly clip, located on the inboard side of trailing arm.

(6) Remove sensor wire fastener from rear brake hose bracket.

(7) Remove outboard sensor assembly retainer nut.

(8) Remove sensor head screw.

(9) Carefully, remove sensor head from adapter assembly. If the sensor has seized, due to corrosion, DO NOT USE PLIERS ON SENSOR HEAD. Use a hammer and a punch and tap edge of sensor ear, rocking the sensor side to side until free.

INSTALLATICN

(1) Installation is reverse order of removal. Be sure to coat sensor with High Temperature Multi-purpose E.P. Grease before installing into adapter assembly. Tighten screw to 7 N-m (60 in.lbs.) torque.