Electronic Components

Fig. 8 - Location Controller AntiLock Brake (CAB):

CONTROLLER ANTI-LOCK BRAKE (CAB)

REMOVAL

(1) Turn vehicle ignition off.

(2) Raise vehicle on hoist, (CAB) access for removal is from the underside of the vehicle.

(3) Remove transmission oil cooler line routing clip.

(4) Disconnect the wiring harness 60 way connector from the Controller Anti-Lock Brake Module (CAB). VERIFY THAT THE VEHICLE IGNITION IS OFF BEFORE REMOVING THE 60 WAY CONNECTOR.
(5) Remove the 3 (CAB) module mounting bolts.

(6) Remove tbe (CAB) module from the vehicle.

INSTALLATION

(1) The Controller Anti-Lock Brake (CAB) module installation is done in the reverse order of removal.

Fig. 9 - Pump/Motor and Anti-Lock System Relays:

REMOVE/INSTALL

See Fig. 9; Open Power Distribution Center cover. Locate component and remove by pulling upward and install by pushing firmly into position.