Early Production

Hydraulic Assembly:

REMOVAL
1. Depressurize hydraulic accumulator as outlined under MAINTENANCE PROCEDURES.
WARNING: Failure to depressurize hydraulic accumulator, prior to performing this operation, may result in personal injury and/or damage to painted surfaces.
2. Remove fresh air intake ducts (2).
3. Disconnect five electrical connectors (including the one on the pump/motor) which runs across engine compartment, near the pump/motor high and low pressure hoses.
4. Disconnect high and low pressure hoses from hydraulic assembly. Cap spigot on reservoir.
5. Disconnect pump/motor electrical connector from engine mount.
6. Loosen the nuts holding the pump/motor to the transmission differential cover.
7. Remove the pump/motor to transmission retainer bolt.
8. Lift pump/motor assembly off of studs and out of vehicle.
9. Remove heat shield from pump/motor and discard.

INSTALLATION
1. Install new heat shield on pump/motor bracket.
2. Reverse procedure to install.