NS-11B Injector 1 & 2 Control Wire For Open Circuit

Complete No Start Test 11, Step A, before proceeding.

1. Turn ignition switch Off, then disconnect SMEC 60-way and 14-way electrical connectors.
2. Connect an ohmmeter between terminal No. 33 of 60-way electrical connector and terminal No. 8 of 14-way electrical connector.
3. If ohmmeter indicates continuity, replace SMEC.
CAUTION: Before replacing the SMEC, check the K16 terminal in cavity No. 8 of the 14-way connector to make sure it is not spread apart causing a poor connection.
4. If ohmmeter does not indicate continuity, locate and repair open in circuit between 14-way and 60-way electrical connector.