NS-11A Check Injector 1 & 2 Control Circuit

Complete No Start Test 9, Step A, before proceeding.

1. Connect diagnostic read-out tool to engine harness connector, then place system in Diagnostic Test Mode.
2. Turn ignition Off, then disconnect SMEC 60-way electrical connector.
3. Connect one end of a jumper wire to terminal No. 33 of SMEC 60-way electrical connector, then place ignition switch in the Run position.
4. Press ATM button on read-out tool, then make and break jumper wire connection to battery positive terminal several times.
5. If injectors 1 and 2 click, proceed to Test 11 step C.
6. If injectors 1 and 2 do not click, proceed to Test 11 step B.