DR-2D MAP Sensor Wires to SMEC For Open Circuit

Complete Driveability Test 2, Step C before proceeding.

1. With diagnostic read-out tool connected to engine test connector, MAP sensor connector disconnected, and system in Sensor Test Mode 08, Connect a jumper wire between dark green/red wire of MAP sensor harness connector and negative battery terminal.
2. If display reads zero volts, locate and repair open circuit in black/light blue wire of sensor harness connector to wiring harness splice.
3. If display reads 5 volts, locate and repair open circuit in dark green/red wire of sensor harness connector to SMEC.