DR-18F Sensor Calibration MAP Sensor

Complete Driveability Test 18, Step E before proceeding.

This test must be performed with engine warm.

1. With diagnostic read-out tool connected to engine test connector, place system in Sensor Test Mode 08.
2. Disconnect vacuum hose from MAP sensor and connect an auxiliary vacuum supply to MAP sensor.
3. Apply 5 inches of vacuum and record voltage displayed on read-out tool, then apply 20 inches of vacuum and record voltage displayed.
4. Subtract voltage at 20 inches from voltage at 5 inches to get voltage difference.
5. If read-out tool shows an un-interrupted change of voltage between 5 and 20 inches of vacuum, and if voltage difference is 1.1---1.4 volts, repair vacuum line to MAP sensor for a restriction.
6. If read-out tool shows an interrupted change of voltage between 5 and 20 inches of vacuum, or if voltage difference is not between 1.1 and 1.4 volts, replace MAP sensor.