DR-16E Manifold Absolute Pressure Sensor

Complete Driveability Test 16, Step D before proceeding.

This test must be performed with engine cold.

1. With diagnostic read-out tool connected to engine test connector, tee a vacuum gauge into vacuum line at MAP sensor, then start engine.
2. Place system into Engine Running Test Mode 68.
3. If vacuum on display is within 1 inch of that of gauge, proceed to Test 16 step G for Turbo II modes, Test 17 for Turbo 1 models.
4. If vacuum on display is not within 1 inch of that of gauge, proceed to Test 16 step F.