DR-10C A/C Cutout Relay Pull-In Coil Circuit

Complete Driveability Test 10, Step A before proceeding.

1. Turn ignition switch Off, disconnect 60-way electrical connector from SMEC.
2. Connect a voltmeter between dark blue/orange wire of A/C relay single connector and ground.
3. Connect a jumper wire between SMEC 60-way electrical connector terminal No. 57 and ground.
4. Place ignition switch in Run position.
5. If voltmeter indicates battery voltage, replace SMEC.
6. If voltmeter indicates no voltage, proceed to Test 10 step D.