DR-10A Fault Code 33 A/C Cutout Relay

Complete Driveability Test 1, Step A before proceeding.

NOTE: In order for the A/C cutout relay to operate, the radiator fan relay must be operating correctly. Do not proceed with test unless they are. If they are not working, disregard fault code 33.
1. Connect a voltmeter between dark blue/orange wire of A/C cutout relay single connector and ground.
2. Place ignition switch in Run position.
3. If voltmeter reads within 1 volt of battery voltage, proceed to Test 10 step B.
4. If voltmeter reads 0 to 1 volt, proceed to Test 10 step C.