13D Auto Shutdown Relay Output Circuit

1. With [1][2]power module 10-way connector disconnected, disconnect wire from ignition coil positive terminal.
2. Disconnect in-tank fuel pump electrical connector and injector 6-way connector.

10-way Power Module Connector:

3. Connect an ohmmeter between cavity 6 of [1][2]power module 10-way connector and ground.
4. If ohmmeter does not indicate continuity, replace [1][2]power module.
CAUTION: Before replacing the [1][2]power module make sure the terminal in cavity No. 4 of the 10-way connector are not spread apart so they cannot touch the power module pin.
5. If ohmmeter indicates continuity, check wire from cavity 6 for a short to ground. If circuit is satisfactory, replace power module.