10C Injector 1 & 2 Wires to Power Module

1. Turn ignition switch Off, then disconnect [1][2]power module 10-way connector.

10-way Power Module Connector:

2. Connect an ohmmeter between cavities 5 and 6 of connector.
3. If ohmmeter indicates continuity, proceed to Test 10 step D.
4. If ohmmeter does not indicate continuity, locate and repair open in circuit from cavity 5 or 6.
NOTE: If wire in cavity No. 6 is the open one the problem is between the injector harness and where it splices into the main harness.