DR-7C Throttle Position Sensor Wires to Logic Module

1. With diagnostic read-out tool connected to engine harness connector, disconnect throttle position sensor connector.
2. Place system in Sensor Test Mode 05. Note that display readings must be divided by 10.
3. Connect a jumper wire between orange/dark blue wire of throttle position sensor connector and negative battery terminal.
4. If display reads zero volts, locate and repair open circuit in black/light blue wire of throttle position sensor connector to engine harness splice.
5. If display reads five volts, locate and repair open circuit in orange/dark blue wire of throttle position sensor connector to logic module.