DR-13 Fault Code 37 Shift Indicator Lamp

1. Place ignition switch in the Off position, then disconnect logic module white electrical connector.
2. Place ignition switch in Run position, then connect a jumper wire between logic module white electrical connector terminal No. 15 and ground.
3. If shift indicator is illuminated, replace logic module.
CAUTION: Before replacing the logic module check the terminal in cavity No. 15 of the white connector to make sure it is not crushed causing a poor connection.
4. If shift indicator lamp is not illuminated, check bulb. If bulb is satisfactory, wiring to terminal No. 15 of logic module white electrical connector and ignition feed voltage to lamp.