Throttle Position Sensor: Service and Repair

Fig. 6 Typical throttle body assembly:

1. Disconnect battery ground cable.
2. Disconnect throttle body 6-way connector on all 1984-86 models and 1987 Shelby Charger or TPS electrical connector on 1987 models exc. Shelby Charger, Fig. 6.
3. Remove TPS-to-throttle body attaching screws.
4. Unfasten wiring clip from convoluted tube, then remove mounting bracket.
5. Lift TPS off throttle shaft and remove O-ring.
6. Disconnect three TPS wires from convoluted tubing on all 1984-86 models and 1987 Shelby Charger.
7. Lift each locking tab inside 6-way connector with a small screwdriver and remove TPS wire blade terminals. Note position of wires for assembly reference.
8. Reverse procedure to install, using new O-ring. Torque TPS attaching screws to 17-20 inch lbs.