9B Spark Control Wire Between Logic & Power Module

1. Disconnect red [1][2]power module connector, then turn ignition switch Off.
2. Remove jumper wire from terminal No. 6 of white connector.
3. Disconnect [1][2]power module 12-way connector, then connect one lead of an ohmmeter to terminal No. 6 of red connector, and other lead to terminal No. 10 of 12-way connector.
4. If ohmmeter shows continuity, check terminal No. 10 of 12-way connector for damage that would cause a poor connection. If connector is good, replace [1][2]power module.
5. If ohmmeter shows no continuity, locate and repair open circuit in wire.