17B ASD Pull-In Coil Circuit at Power Module

1. Turn ignition switch Off, then disconnect 12-way connector from [1][2]power module.
2. Connect a voltmeter between pin 5 of [1][2]power module and ground, then turn ignition switch to Run position.
3. If voltmeter reads within 1 volt of battery voltage, locate and repair open or short in wire from terminal No. 5.
CAUTION: Check the terminal in cavity No. 12 of the 12-way to make sure it is not spread apart causing a poor connection.
4. If voltmeter reads 0---1 volt, replace [1][2]power module.