Test 12-Step D, Checking For A Shorted Injector

1. Disconnect injector 6-way connector, then connect an ohmmeter between tan wire of connector and ground.
2. If ohmmeter does not indicate continuity, replace [1][2]power module.
CAUTION: Before replacing the [1][2]power module make sure the terminals of the power module connectors are not spread apart so they cannot touch the power module pins.
3. If ohmmeter indicates continuity, disconnect injector No. 3 connector. Replace injector No. 4 if continuity still exists or injector No. 3 if it does not.