Test 11-Step A, Fault Code 26 - Injectors 1 & 2

1. Connect diagnostic read-out tool to engine test connector.
2. Turn ignition switch off, then connect a voltmeter between white wire of injector 6-way connector and ground.
3. Disconnect electrical connectors from injector Nos. 3 and 4 and red connector from logic module.
4. Connect one end of a jumper wire to red connector terminal No. 2, then turn ignition switch to Run position.
5. Press ATM button on read-out tool, then make and break jumper wire connection to ground several times.
6. If voltmeter pulsates as connection is made, replace logic module.
CAUTION: Before replacing the logic module make sure the terminal in cavity No. 2 is not crushed so that it cannot touch the logic module pin.
7. If voltmeter does not pulsate as connection is made, proceed to Test 11 step B.