Test 8-Step C, Ignition Coil Wire For an Open

1. With ignition switch in Off position, disconnect 10-way connector from [1][2]power module.
2. Connect an ohmmeter between negative terminal of ignition coil and terminal No. 1 of 10-way connector.
3. If ohmmeter shows continuity, replace [1][2]power module.
CAUTION: Before replacing the [1][2]power module make sure the terminals in cavity No. 1 are not spread apart so they cannot touch the power module pins.
4. If ohmmeter shows no continuity, locate and repair open circuit in wiring from terminal No. 1 of power module 10-way electrical connector.