Test 14-Step H, Checking 8 Volts at Power Module
1. Turn ignition switch Off, then disconnect 12-way [1][2]power module electrical connector.
2. Connect a voltmeter between pin 12 of [1][2]power module and ground, then turn ignition switch to Run position.
3. If voltmeter reads 7.5 to 9 volts, locate and repair open or short in wire between terminal No. 12 and logic module.
NOTE: Make sure the terminal in cavity No. 12 is not spread apart so that it cannot touch the [1][2]power module pin.
4. If voltmeter indicates no voltage, proceed to Test 14 step I.