DR-8B Checking Charge Sensor Wires

1. With ignition switch in Off position, connect charge sensor electrical connector.
2. Disconnect logic module red and blue electrical connectors.
3. Connect an ohmmeter between red and blue connector terminals No. 25.
4. If ohmmeter indicates resistance, replace logic module.
CAUTION: Before replacing the logic module, make sure the terminal in cavity No. 25 of the blue connector is not crushed so that it cannot touch the logic module pin.
5. If ohmmeter does not indicate resistance, check wiring from terminal No. 25 of logic module blue electrical connector to charge sensor for an open circuit.