Instrument Panel Center & Right Side (23-19-40-00)

Problem Repair

1. Check the glove box door latch by pushing Bend striker forward to tighten door. lightly on door.

2. Check lock housing by touching lightly. Check to see if housing is installed properly. If knob is loose, replace it.

3. Check for objects inside of glove box. Remove loose objects.

4. Open glove box. If rattle stops or Remove glove box assembly and tuck something rubs on box, the A/C resistor wires forward. Clip or tape wires as
block harness, capacitor wires or the required to heater - A/C unit. Reinstall
antenna cable are rattling or rubbing glove box. Check to see that wires do
on back of glove box. not rub back of box.

5. Glove box rubs on the right side of Loose A/C-Heater to panel bracket, push trim bezel. panel in at the left of glove box so that
the right side of glove box no longer rubs. Tighten bracket (Omni, Horizon, Turismo, Charger, Rampage, and Scamp only). Loosen the 3 mounting screws, hold glove box to left and retighten screws from left to right.

6. Press on the A/C unit (if equipped) Refer to Technical Service Bulletin with your hand while engine is running #24-05-83.
to reduce or stop buzz.

7. Refer to "Underhood" section.
Floor Gear Shift

01 Manual Lever 02 Auto Park Button 03 Shift Cable

Ash Receiver

12 Rivets 13 Screws 14 Lighter 51 Improperly Installed

Radio

15 Knobs 16 Lens 17 ETR Buttons

Trim Bezels

19 Screws - Loose/Missing 20 Clips 11 Broken

Glove Box

26 Latch Rattle 27 Lock Housing 29 Door Rubs on Bezels
Console

04 Side Panels 05 Cubby Box 07 Ash Receiver 08 Lighter 09 Outlet - Vent 10 Light 18 Bin

Heater - A/C Unit

21 Temp. Door (Htr. only) 68 A/C Unit Rattle 22 Loose A/C Ducts

Instrument Panel

23 Loose Attaching Screws 24 Loose Brackets

Wiring

32 Wiring Rattles on Glove Box Refer to Top Cover Section for further codes