Front Hub/Bearing/ Seal - Manual Revision

84chrysler11

Models


All 1981 Through 1984 Domestic Front Wheel Drive Models


Subject


Front Hub/Bearing/ Seal Removal - 1984 Service Manual Revision


Index


SUSPENSION


Date February 20, 1984


No.


02-01-84 P-534-C
The following revision should be made to the 1984 service manuals for front wheel drive vehicles. This revision updates the installation procedure of Special Tool C-4811 when removing the hub from the knuckle. In some cases it is necessary to back out all three bearing retainer screws. Back out the three screws until they contact the hub, then continue backing them out equal amounts until they unseat the hub. When the screws run out of threads the hub removing tool can then be installed with the three special screws. Complete the operation as indicated in the service manual.

The reason for this update is due to the type of bearing retainer screws used in production beginning with some 1981 models that may prevent the installing of the small adapter screw.

The 1984 model tools and procedure for hub bearing and seal replacement is applicable on all domestic front wheel drive models 1978 through 1984.



Cut reprints out on dotted lines. Glue back of sheets and apply to the following pages:

^ Apply reprint page 2-17 to right hand column in service publication #81-270-4003, page 2-17.



^ Apply reprint page 2-14 to right hand column in service publication #81-370-4010.
POLICY: Information only



Apply on page 2-17 in Service Manual Publication No. 81-270-4003



Apply on page 2-14 in Service Manual Publication No. 81-370-4010