Shifter A/T: Service and Repair

Shift Lever Replacement

Removal Procedure

1. Remove the steering column shroud. Refer to Steering Column Shroud Replacement Steering Column Shroud Replacement.

2. Roll back the shift lever seal on the shift lever until the shift lever bolt is exposed.

3. Disconnect any electrical connectors as needed.





4. Remove the shift lever bolt (2).

5. Remove the shift lever (1).

Installation Procedure





1. Install the shift lever (1).

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the shift lever bolt (2) and tighten to 20 Nm (15 lb ft).

3. Connect all electrical connectors.

4. Position the shift lever seal.

5. Install the steering column shroud. Refer to Steering Column Shroud Replacement Steering Column Shroud Replacement.