B3205
DTC B3205
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptors
DTC B3205 00
-
Window Inactive Over Current Fault
DTC B3205 0B
-
Window Motor Fast Over Current Fault
Diagnostic Fault Information
Circuit/System Description
The driver door switch (DDS) and passenger door switch (PDS) control the power window functions through the power window motor up and down control circuits. The door switches monitor the control circuits for fault conditions when up or down operation is requested prior to activating the function and during operation.
Conditions for Running the DTC
* Battery voltage must be between 9-16 volts.
* The ignition switch is in the ON position.
Conditions for Setting the DTC
B3205 00
The DDS or PDS detects a short to ground or short to voltage on their respective window motor control circuit.
B3205 0B
The DDS or PDS has detected excessive current flow on their respective window motor control circuit.
Action Taken When the DTC Sets
The affected power window will be inoperative.
Conditions for Clearing the DTC
* The DTC will be current for as long as the fault is present.
* When the fault is no longer present, the DTC will be a history DTC.
* A history DTC will clear after 50 ignition cycles.
Diagnostic Aids
The DTC can be set due to excessive physical resistance in the window regulator assembly. Ensure proper mechanical operation of the regulator assembly prior to replacing electrical components.
Reference Information
Schematic Reference
Moveable Window Schematics Electrical Diagrams
Connector End View Reference
Component Connector End Views 1-2 Shift Solenoid (SS) Valve (M30)
Description and Operation
Power Windows Description and Operation Power Windows
Electrical Information Reference
* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs
Scan Tool Reference
Control Module References Control Module References for scan tool information
Circuit/System Verification
Igntition ON, observe the operation of the front power windows while commanding each window UP and DOWN by using their respective window switches, each window should perform the UP and DOWN function.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the appropriate front window motor.
2. Connect a test lamp between the control circuit terminal A and control circuit terminal B.
3. Ignition ON, command the window UP and DOWN by using the front door window switch. The test lamp should illuminate when commanding the UP and DOWN states.
• If the test lamp is always OFF during either of the commands, test either control circuit for a short to ground or an open/high resistance. If the circuits test normal, replace the door module.
• If the test lamp is always ON, test either control circuit for a short to voltage. If the circuits test normal, replace the door module.
4. If all circuits test normal, test or replace the front window motor.
Component Testing
1. Ignition OFF, disconnect the harness connector at the appropriate window motor.
2. Install a 30A fused jumper wire between one of the control terminals and 12V. Momentarily install a jumper wire between the other control terminal and ground. Reverse the jumper wires at least two times, the window motor should perform the UP and DOWN functions.
• If it does not perform as specified, replace the window motor.
Repair Instructions
Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.
Front Side Door Window Regulator Replacement (Power) Front Side Door Window Regulator Replacement (Power)Front Side Door Window Regulator Replacement (Manual) Front Side Door Window Regulator Replacement (Manual)
Control Module References Control Module References for DDS and PDS replacement, setup and programming.