Rear Output Shaft Housing O-Ring Seal Replacement

Rear Output Shaft Housing O-Ring Seal Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Drain the transfer case fluid. Refer to Transfer Case Fluid Replacement Transfer Case Fluid Replacement.

3. Remove the rear propeller shaft. Refer to Propeller Shaft Replacement Service and Repair.

4. Remove the rear output shaft housing. Refer to Rear Output Shaft Housing Removal in Transfer Case Disassemble 1. Transfer Case Disassemble.

5. Remove the transfer case rear output shaft housing seal O-ring.

Installation Procedure

1. Install the transfer case rear output shaft housing seal O-ring.

2. Install the rear output shaft housing. Refer to Rear Output Shaft Housing Installation in Transfer Case Assemble 8. Transfer Case Assemble.

3. Install the rear propeller shaft. Refer to Propeller Shaft Replacement Service and Repair.

4. Fill the transfer case with fluid. Refer to Transfer Case Fluid Replacement Transfer Case Fluid Replacement.

5. Lower the vehicle.