Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake

Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake

Removal Procedure




1. Remove the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side Engine Mount Strut Bracket Replacement - Right Side.

2. Remove the radiator inlet hose from the water outlet. Refer to Radiator Inlet Hose Replacement Radiator Inlet Hose Replacement.

3. Remove the power steering fluid reservoir bracket bolts (1).

4. Remove and reposition the power steering fluid reservoir bracket (2) out of the way.




5. Disconnect the engine wiring harness electrical connector (8) from the bank 2 intake camshaft position (CMP) sensor (7).




6. Remove the CMP sensor bolt and sensor (3).

Installation Procedure





Caution: Refer to Fastener Caution Fastener Caution.

1. Install the CMP sensor (3) and bolt.

Tighten the bolt to 10 Nm (89 lb in).




2. Connect the engine wiring harness electrical connector (8) to the bank 2 intake CMP sensor (7).




3. Position and install the power steering fluid reservoir bracket (2).

4. Install the power steering fluid reservoir bracket bolts (1).

Tighten the bolts to 9 Nm (8 lb in).

5. Install the radiator inlet hose to the water outlet. Refer to Radiator Inlet Hose Replacement Radiator Inlet Hose Replacement.

6. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side Engine Mount Strut Bracket Replacement - Right Side.