Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake

Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake

Removal Procedure




1. Remove the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side Engine Mount Strut Bracket Replacement - Right Side.

2. Remove the radiator inlet hose from the water outlet. Refer to Radiator Inlet Hose Replacement Radiator Inlet Hose Replacement.

3. Remove the power steering fluid reservoir bracket bolts (1).

4. Remove and reposition the power steering fluid reservoir bracket (2) out of the way.




5. Disconnect the engine wiring harness electrical connector (6) from the bank 2 intake camshaft position (CMP) actuator solenoid valve.




6. Remove the CMP actuator solenoid valve bolt and valve (3).

7. Inspect the CMP actuator solenoid valve seal for damage and replace as necessary.

Installation Procedure




1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.

Caution: Refer to Fastener Caution Fastener Caution.

2. Install the CMP actuator solenoid valve (3) and bolt.

Tighten the bolt to 10 Nm (89 lb in).




3. Connect the engine wiring harness electrical connector (6) to the bank 2 intake CMP actuator solenoid valve.




4. Position and install the power steering fluid reservoir bracket (2).

5. Install the power steering fluid reservoir bracket bolts (1).

Tighten the bolts to 9 Nm (80 lb in).

6. Install the radiator inlet hose to the water outlet. Refer to Radiator Inlet Hose Replacement Radiator Inlet Hose Replacement.

7. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side Engine Mount Strut Bracket Replacement - Right Side.