P166B

DTC P166B

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provide an overview of each diagnostic category.

DTC Descriptor

DTC P166B

-
Intake Air (IA) Heater Over Temperature

Diagnostic Fault Information






Circuit/System Description

The intake air heater is located at the intake manifold outlet and is used to heat the air before it enters the inner cooler during cold engine operation. The engine control module (ECM) determines when to request the glow plug control module to turn ON and OFF the intake air heater. The glow plug control module controls the intake air heater current by monitoring the feedback circuits of the intake air heater. The intake air heater will only be commanded ON while the engine is running if required by the ECM.

Conditions for Running the DTC

* The intake air heater is commanded ON

* The engine is running for more than 40 seconds.

* Engine coolant temperature is less than 60°C (140°F).

Conditions for Setting the DTC

* DTC's P0154A, P0154C, or P154D are not set.

* Battery volage is between 9-16 V.

* The IAH temperature is more than 80°C (176°F) for more than 3 seconds.

Action Taken When the DTC Sets

DTC P166B is a type B DTC.

Conditions for Clearing the DTC

DTC P166B is a type B DTC.

Reference Information

Schematic Reference

Engine Controls Schematics [1][2]Electrical Diagrams

Connector End View Reference

Component Connector End Views 1-2 Shift Solenoid (SS) Valve (M30)

Description and Operation

Intake Air Heater System Description Intake Air Heater System Description

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

1. Verify the intake air heater is clear of debris and aftermarket devices.

2. Verify DTC's P0154A, P0154C, or P154D are not set.

3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

Circuit/System Testing

Note:
You must perform the Circuit/System Verification before proceeding with Circuit/System Testing.

1. Ignition OFF, disconnect the harness connector at the E24 intake air heater.

2. Ignition ON, verify the scan tool IAH Temp. Ckt. Status parameter is High/Open.

• If not the specified value, test the Intake Air Heater Temperature Signal circuit terminal 1 for a short to ground. If the circuit tests normal, replace the K34 glow plug control module.

3. If all circuits test normal, replace the E24 intake air heater.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Intake Air Heater Replacement Service and Repair

* Control Module References Control Module References for glow plug control module replacement, setup, and programming