Engine Mount Bracket Replacement - Left Side

Engine Mount Bracket Replacement - Left Side

Removal Procedure





Caution:
Refer to Engine Mounting Caution Engine Mounting Caution.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the engine mount to engine mount bracket bolts.





Caution:
When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or crankshaft balancer. Jacking against the oil pan may cause it to crack or break.

Note:
Raise the engine only enough to permit removal of the engine mount bracket.

3. Using a jack on the square tab at the rear of the engine block and raise the engine, left side shown.





4. Remove the engine mount bracket mounting nuts

5. Remove the engine mount bracket from the vehicle.

Installation Procedure





1. Install the engine mount bracket to the vehicle.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the engine mount bracket retaining nuts and tighten to 50 Nm (37 lb ft).

3. Lower the engine.





4. Install the engine mount to engine mount bracket bolts and tighten to 60 Nm (44 lb ft).

5. Lower the vehicle.