Rear Door Window Glass: Service and Repair

Rear Side Door Window Replacement

Removal Procedure

1. Place the rear door window in the full down position.

2. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement Rear Side Door Trim Panel Replacement.

3. Remove the water deflector.





4. Lower the window (1) to align the bolts with the access holes in the inner door panel.

5. Remove the window guide bolts (2).

6. Remove the front part of the rear door window channel weatherstrip this will allow the window to slide forward.

7. Remove the rear door front applique. Refer to Rear Door Frame Applique Replacement .

Warning:
Refer to Glass and Sheet Metal Handling Warning Glass and Sheet Metal Handling Warning.


8. In order to remove the window out of the frame, carefully grasp and tilt the window as you guide the window up and forward.

9. Remove the window from the door.

Installation Procedure





1. With the regulator in the remove/load position, install the window (1) to the door.

2. Tilt the window forward and carefully guide the window into the rear channel.

3. Position the window to an upright position.

4. Install the rear door front applique. Refer to Rear Door Frame Applique Replacement .

Note:
Ensure that the window is fully seated into the channels.

5. Install the front part of the rear door window channel weatherstrip.

6. Loosely tighten the window guide bolts (2).

Note:
Do not operate the regulator motor without supporting the window. Ensure that the window remains in the channels when operating the regulator motor.

7. Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the channels.

8. Lower the window to the full down position.

Caution:
Refer to Fastener Caution Fastener Caution.

9. Tighten the 2 window guide bolts (2). Tighten the bolts to 10 Nm (89 lb in).

10. Install the water deflector.

11. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement Rear Side Door Trim Panel Replacement.

12. Inspect the window for proper operation.