Fuel Tank Fuel Pump Module Replacement - Secondary (With Out)

Fuel Tank Fuel Pump Module Replacement - Secondary (With Out)

Special Tools

CH-48482 - Fuel Tank Sender Wrench

For equivalent region tools, refer to Special Tools (Diagnostic Tools) Special Tools (Diagnostic Tools).

Removal Procedure

Warning: Refer to Gasoline/Gasoline Vapors Warning Service Precautions.


1. Remove the fuel tank. Refer to Fuel Tank Replacement (FWD) Fuel Tank Replacement (FWD)Fuel Tank Replacement (AWD) Fuel Tank Replacement (AWD).




2. Disconnect the electrical connector (1).

3. Disconnect the evaporative emission line (2). Refer to Plastic Collar Quick Connect Fitting Service Procedures.




4. Using the CH-48482 - wrench, remove the cam lock ring (1) by turning counterclockwise.




5. Partially raise the secondary fuel pump module and disconnect the crossover tube (1) by squeezing the plastic retaining tabs (2).




6. Remove the secondary fuel tank module (1) and the O-ring (2).

Installation Procedure




1. Partially install the secondary fuel pump module and connect the crossover tube (1) by sliding into position.




2. Install a NEW O-ring (2) and the secondary fuel tank module (1).




3. Using the CH-48482 - wrench, install the cam lock ring (1) by turning clockwise.




4. Connect the electrical connector (1).

5. Connect the evaporative emission line (2). Refer to Plastic Collar Quick Connect Fitting Service Procedures.

6. Install the fuel tank. Refer to Fuel Tank Replacement (FWD) Fuel Tank Replacement (FWD)Fuel Tank Replacement (AWD) Fuel Tank Replacement (AWD).