VIN 6

Fuel Temperature Sensor Replacement

Removal Procedure

1. Remove the engine cover. Refer to Engine Cover Replacement (Service and Repair).
2. Remove the charged air inlet tube. Refer to Charge Air Cooler Inlet and Outlet Duct Replacement (Inlet) (Charge Air Cooler Inlet and Outlet Duct Replacement (Inlet)) Charge Air Cooler Inlet and Outlet Duct Replacement (Outlet) (Charge Air Cooler Inlet and Outlet Duct Replacement (Outlet)).
3. Remove the rear fuel line retainer and bolt.
4. Remove the fuel line retainer at center of engine.
5. Remove the glow plug module and bracket. Refer to Glow Plug Control Module Replacement (Glow Plug Control Module Replacement).




6. Disconnect the fuel rail temperature (FRT) sensor electrical connector.




7. Remove the FRT sensor from the fuel line.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the FRT sensor electrical connector and tighten to 22 Nm (16 lb ft).




2. Connect the FRT sensor electrical connector.
3. Install the fuel line retainer center of engine.
4. Install the rear fuel line retainer.
5. Install the charged air inlet tube. Refer to Charge Air Cooler Inlet and Outlet Duct Replacement (Inlet) (Charge Air Cooler Inlet and Outlet Duct Replacement (Inlet)) Charge Air Cooler Inlet and Outlet Duct Replacement (Outlet) (Charge Air Cooler Inlet and Outlet Duct Replacement (Outlet))
6. Install the glow plug module and bracket. Refer to Glow Plug Control Module Replacement (Glow Plug Control Module Replacement).
7. Prime the fuel system. Refer to Fuel System Priming (Fuel System Priming).
8. Once engine starts, inspect for leaks.
9. Install the engine cover. Refer to Engine Cover Replacement (Service and Repair).