FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

C0299




DTC C0299

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptors
DTC C0299 00
- Brake Booster Pressure Sensor Performance

DTC C0299 5A
- Brake Booster Pressure Sensor Performance Plausibility Failure

Circuit/System Description

The power brake booster vacuum sensor monitors the vacuum level in the power brake booster. When the electronic brake control module (EBCM) detects the vacuum level is low a DTC is set.

Conditions for Running the DTC

The engine is running.

Conditions for Setting the DTC

Low or no vacuum is detected in the power brake booster after start-up.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Reference Information
Schematic Reference

Antilock Brake System Schematics ([1][2]Antilock Brakes / Traction Control Systems)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

1. Verify that a vacuum leak is not present, refer to Brake Assist System Diagnosis (Component Tests and General Diagnostics).
2. Verify that DTC C1100 is not set.

If DTC is set, refer to DTC C1100 (C1100).