Crankshaft Position Sensor Replacement

Crankshaft Position Sensor Replacement

Removal Procedure




1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
3. Disconnect the crankshaft position (CKP) sensor electrical connector.




4. Remove the CKP sensor bolt.
5. Remove the CKP sensor.
6. If necessary, remove the CKP sensor spacer bolts.
7. If necessary, remove the CKP sensor spacer.

Installation Procedure






Important: The crankshaft position sensor spacers are machined with different timing positions. However, if the crankshaft position sensor spacer requires replacement, replace with a grade "C" spacer.

1. If necessary, lubricate a NEW CKP spacer O-ring with clean engine oil.
2. If necessary, install the NEW O-ring to the CKP sensor spacer.
3. If necessary, install the CKP sensor spacer.

Notice: Refer to Fastener Notice.

4. If necessary, install the CKP sensor spacer bolts.

Tighten the bolts to 10 N.m (89 lb in).

5. Install the CKP sensor.
6. Install the CKP sensor bolt.

Tighten the bolt to 10 N.m (89 lb in).




7. Connect the CKP sensor electrical connector.
8. Lower the vehicle.
9. Connect the negative battery cable.