Fuel Temperature Sensor: Service and Repair

Fuel Temperature Sensor Replacement

Removal Procedure

1. Remove the engine cover.
2. Remove the charged air inlet tube.
3. Remove the rear fuel line retainer and bolt.
4. Remove the fuel line retainer at center of engine.
5. Remove the glow plug module and bracket.




6. Disconnect the fuel rail temperature (FRT) sensor electrical connector.




7. Remove the FRT sensor from the fuel line.

Installation Procedure






Notice: Refer to Fastener Notice.

1. Install the FRT sensor electrical connector.

Tighten the FRT sensor to 22 N.m (16 lb ft).




2. Connect the FRT sensor electrical connector.
3. Install the fuel line retainer center of engine.
4. Install the rear fuel line retainer.
5. Install the charged air inlet tube.
6. Install the glow plug module and bracket.
7. Prime the fuel system. Refer to Fuel System Priming.
8. Once engine starts, inspect for leaks.
9. Install the engine cover.