B3808

DTC B3808

CIRCUIT DESCRIPTION
The body control module (BCM) internally grounds the door lock relay control circuit for the door lock relay when it receives a switched ground signal from any door lock switch or with a keyless entry lock transmission. When the BCM grounds the door lock relay control circuit, the door lock relay is energized and locks the doors.

DTC DESCRIPTOR
This diagnostic procedure supports the following DTC:
DTC B3808 Door Lock Switch Relay Circuit

CONDITIONS FOR RUNNING THE DTC
Battery voltage is between 916 volts.
The DTC will set if the door lock function is active or inactive.

CONDITIONS FOR SETTING THE DTC
The DTC will set if the door lock relay control circuit is shorted to ground or open for more than one second.

ACTION TAKEN WHEN THE DTC SETS
If a short to ground is present on the door lock relay control circuit, the door lock relay will be energized and the door lock actuators will be held in the lock position and will not unlock.
If an open condition is present on the door lock relay control circuit, the doors will unlock but not lock.

CONDITIONS FOR CLEARING THE DTC
When the fault is no longer present, the BCM changes the current DTC to a history DTC. The BCM will clear the history DTC after 50 faultfree ignition cycles.

DIAGNOSTIC AIDS
DTC B3808 could also set if the door lock relay winding is open.
If both DTC B3808 and B3809 are set as current, the battery positive voltage circuit or the Door LKS fuse could be open. If the Door LKS fuse is open, the cause is most likely one of the following:
- A short to ground in the relay battery positive voltage circuit
- A short to ground in the door lock actuator lock or unlock control circuits

TEST DESCRIPTION

Step 1 - Step 14:

The numbers below refer to the step numbers on the diagnostic table.
2. Listen for an audible click when the door lock relay operates. Command both the ON and OFF states. Repeat the commands as necessary.
3. This step tests for voltage at the coil side of the door lock relay. The Door LKS fuse supplies power to the coil side of the Door LKS Relay.
4. This step verifies that the BCM is providing ground to the Door LKS Relay.
5. This step tests if ground is constantly being applied to the Door LKS Relay.