Park Brake Shoe Replacement (RPO Nys)

Park Brake Shoe Replacement (RPO NYS)

Caution: Refer to Brake Dust Caution.

Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle.
3. Remove the tire and wheel assembly.





4. Relieve the tension from the park brake cable by pulling down on the intermediate cable, then release the cable from the equalizer bar.





5. Remove the rear park brake bracket bolt.





6. Remove the park brake cable from the park brake actuator lever.
7. Remove the park brake assembly and backing plate from the steering knuckle.
8. Remove the park brake shoe retaining clip bolt and retaining clip.
9. Remove the park brake shoe from the actuator.

Installation Procedure
1. Install the park brake shoe to the actuator.
2. Install the park brake shoe retaining clip and retaining clip bolt.
^ Tighten the bolt to 3 N.m (25 lb in).

Notice: Refer to Fastener Notice.

3. Install the park brake assembly and backing plate to the steering knuckle.





4. Install the park brake cable to the park brake actuator lever.





5. Install the rear park brake bracket bolt.
^ Tighten the bolt to 61 N.m (45 lb ft).





6. Install the park brake cable to the equalizer bar.
7. Adjust the park brake shoe. Refer to Park Brake Adjustment.
8. Install the tire and wheel assembly.
9. Lower the vehicle.