Transmission Input Shaft Seal Replacement

Transmission Input Shaft Seal Replacement
^ Tools Required
- J 23907 Slide Hammer
- J 44748 Seal Remover
- J 44731 Input Shaft Oil Seal Installer

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the rear propeller shaft.
3. Remove the transmission.

Important: The clutch actuator hose can remain connected to the clutch actuator. Disconnecting the hose from the clutch actuator will allow the hydraulic fluid to drain from the hydraulic system.

4. Remove the clutch actuator cylinder bolts. Do not disconnect the hose from the actuator.
5. Remove the clutch actuator cylinder.





6. Remove the front oil seal using J 23907 (2) and J 44748 (1).

Installation Procedure





1. Position the NEW seal in the front case with the part number facing out.
2. Using J 44731 install the input shaft seal.





3. Position the clutch actuator cylinder.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the clutch actuator cylinder bolts.
^ Tighten the bolts to 8 Nm (71 inch lbs.).
5. Install the transmission.
6. Install the rear propeller shaft.
7. Check the transmission fluid level. Add if necessary.
8. Lower the vehicle.