Transmission Housing Oil Seal Replacement - Rear (2WD)

Transmission Housing Oil Seal Replacement - Rear (2WD)
^ Tools Required
- J 8614-01 Pinion Flange Holder
- J 6125-1BSlide Hammer
- J 22834-A Rear Extension Housing Oil Seal Installer
- J 23129 Universal Seal Remover

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the rear propeller shaft.
3. If required, remove the following:
1. The main shaft nut
2. The prop shaft yoke washer
3. The main shaft washer
4. The yoke





4. Remove the rear seal using J 6125-B (1) and J 23129 (2).

Installation Procedure





1. Using J 22834-A install the NEW rear oil seal.





2. If required, install the following:
1. The yoke
2. A NEW main shaft washer
3. A NEW prop shaft yoke washer
4. The main shaft nut





3. If required, use J 8614-01 in order to keep the keep yoke from rotating.

Notice: Refer to Fastener Notice in Service Precautions.

4. Tighten the main shaft nut.
^ Tighten the nut to 441 Nm (325 ft. lbs.).
5. Install the rear propeller shaft.
6. Check the transmission fluid level. Add if necessary.
7. Lower the vehicle.