86. Solenoid Valve Retaining Bracket and Resistor Bracket Inspection

Solenoid Valve Retaining Bracket and Resistor Bracket Inspection





1. Important: If any of the following specifications are not met, replace the retaining bracket.

Measure the angle between the surfaces of the following retaining brackets at angle A:
^ Pressure control solenoid 1 (PCS1) and PCS2 retaining bracket (1)
^ Torque converter clutch pressure control solenoid (TCC PCS) retaining bracket (2)
2. Adjust the bracket surfaces to the specified amount.
The angle between the surfaces of the PCS1 and PCS2 retaining bracket and the TCC PCS retaining bracket are approximately 82.84°.