Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Balancer Replacement

^ Tools Required
- J 44643 Flywheel Holding Tool

Removal Procedure





1. Disconnect the negative battery cable.
2. Remove the right wheelhouse panel.
3. Remove the starter motor bolts. Reposition the starter aside. The wiring to the starter does not require removal.





4. Install J 44643 in order to hold the flywheel.
5. Remove the lower fan shroud.





6. Remove the crankshaft balancer bolt.
7. Remove the crankshaft balancer.
8. If required, clean and inspect the crankshaft balancer.

Installation Procedure





1. Lubricate the crankshaft balancer internal hub with clean engine oil.
2. Install the crankshaft balancer on the crankshaft.
3. Lubricate the crankshaft balancer bolt with clean engine oil.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the crankshaft balancer bolt and washer.
^ Tighten the bolt to 353 Nm (260 ft. lbs.).





5. Remove J 44643 .





6. Position the starter motor.
7. Install the starter motor bolts.
^ Tighten the bolts to 78 Nm (58 ft. lbs.).
8. Install the right wheelhouse panel.
9. Install the lower fan shroud.
10. Connect the negative battery cable.