Transfer Case Input Shaft Seal Replacement

Transfer Case Input Shaft Seal Replacement

^ Tools Required
- J 42738 Front Output Shaft Seal Installer

Removal Procedure





1. Remove the transfer case.
2. Remove the input shaft seal, using a flat-tipped screwdriver.

Installation Procedure





1. Position the seal on the input shaft.

Important:
When installing the input shaft seal, make sure that the part numbers on the seal are facing outward (toward the technician). The input shaft seal should be even with the surface of the transfer case after installation.


2. Using the J 42738, install the input shaft seal.
3. Install the transfer case.