Transfer Case Input Shaft Seal Replacement

Transfer Case Input Shaft Seal Replacement
^ Tools Required
- J 42738 Seal Installer

Removal Procedure





1. Remove the transfer case.
2. using a flat-tipped screwdriver, remove the input shaft seal.

Installation Procedure





1. Align the transfer case input shaft seal evenly on the input shaft.

Important: When installing the input shaft seal, make sure that the part numbers on the seal are facing outward (away from the body of the transfer case).


2. Using the J 42738, install the transfer case input shaft seal.

Important: The input shaft seal should be even with the surface of the transfer case after installation.

3. Install the transfer case.
4. Check the fluid level. Add fluid of necessary.