Tie Rod End: Service and Repair

Rack and Pinion Outer Tie Rod End Replacement

^ Tools Required
- J 24319-01 Universal Steering Linkage Puller

Removal Procedure
1. Raise the vehicle. Support the vehicle with suitable safety stands. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.





3. Remove the torque prevailing nut from outer tie rod stud.





4. Loosen the jam nut (2) on the inner tie rod assembly (1).





5. Remove the outer tie rod assembly (2) from the steering knuckle (1) using J 24319-01.





6. Remove the outer tie rod assembly (3) from the inner tie rod assembly (1).

Installation Procedure





1. Connect the outer tie rod assembly (3) to the inner tie rod (1). Do not tighten the jam nut (2).





2. Install the tie rod seal (2) to the outer tie rod assembly (1).
3. Connect the outer tie rod assembly (1) to the steering knuckle (2).

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the torque prevailing nut (3) to the outer tie rod stud (1).
^ Tighten the torque prevailing nut (3) to 50 Nm (37 ft. lbs.).

5. Check the wheel alignment.

Important: Be sure the rack and pinion boot is not twisted after the toe adjustment.