Park Brake Cable Replacement - Intermediate (W/Rear Disc)

Park Brake Cable Replacement - Intermediate (w/Rear Disc)

Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle.





3. For all 15 series vehicles, relieve the tension from the park brake cable by pulling down on the park brake cable in front of the equalizer then removing the cables from the equalizer bar.
4. For 25/35 series vehicles, disable the park brake cable automatic adjuster.
5. For 25/35 series vehicles, disconnect the intermediate cable from the rear park brake cable.





6. Disconnect the intermediate cable from the front cable.
7. Remove the intermediate cable from the vehicle.

Installation Procedure
1. Install the intermediate cable to the vehicle.





2. Connect the intermediate cable to the front cable.
3. For 25/35 series vehicles, connect the intermediate cable to the rear park brake cable.
4. For 15 series vehicles, install the rear park brake cables to the equalizer.





5. For 15 series vehicles, install the equalizer and the nut to the threaded end of the intermediate cable.
Tighten the nut to 3.5 Nm (31 inch lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

6. For 25/35 series vehicles, enable the park brake cable automatic adjuster.
7. Remove the safety stands and lower the vehicle.
8. Adjust the park brake system.