SIR Disabling and Enabling Zone 7

SIR DISABLING AND ENABLING ZONE 7

DISABLING PROCEDURE
1. Turn the steering wheel until the vehicles wheels are pointing straight ahead.

IMPORTANT: Refer to SIR Service Precautions before disabling the SIR System.

2. Turn OFF the ignition.
3. Remove the key from the ignition.
4. Remove the SIR fuse from the fuse block.

IMPORTANT: With the SIR fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation and does not indicate an SIR System malfunction.




5. Remove the connector position assurance (CPA) (1) from the steering wheel module yellow 4-way connector (2) located left of the steering column near the knee bolster.
6. Disconnect the steering wheel module yellow 4-way connector (2).




7. Remove the CPA from the LF seat belt pretensioner yellow 2-way connector (1) located under the driver seat.
8. Disconnect the LF seat belt pretensioner yellow 2-way connector (1) located under the driver seat.




9. Remove the right knee bolster bracket.
10. Remove the CPA from the I/P module yellow 4-way connector (1) located behind the I/P support.
11. Disconnect the I/P module yellow 4-way connector (1).




12. Remove the CPA from the RF seat belt pretensioner yellow 2-way connector (1) located under the passenger seat.
13. Disconnect the RF seat belt pretensioner yellow 2-way connector (1) located under the passenger seat.

ENABLING PROCEDURE
1. Remove the key from the ignition.




2. Connect the steering wheel module yellow 4-way connector (2) located left of the steering column near the knee bolster.
3. Install the connector position assurance (CPA) (1) to the steering wheel module yellow 4-way connector (2).




4. Connect the LF seat belt pretensioner yellow 2-way connector (1) located under the driver seat.
5. Install the CPA to the LF seat belt pretensioner yellow 2-way connector (1) located under the driver seat.




6. Connect the I/P module yellow 4-way connector (1) located behind the I/P support.
7. Install the CPA to the I/P module yellow 4-way connector (1).
8. Install the right knee bolster bracket.




9. Connect the RF seat belt pretensioner yellow 2-way connector (1) located under the passenger seat.
10. Install the CPA to the RF seat belt pretensioner yellow 2-way connector (1) located under the passenger seat.
11. Install the SIR fuse to the fuse block.
12. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
1. The AIR BAG indicator will flash 7 times.
2. The AIR BAG indicator will then turn OFF.
13. Perform the Diagnostic System Check - Vehicle , if the AIR BAG indicator does not operate as described.